Abstract
The article describes theoretical studies of the dependence of geometric parameters of a contact between a tool and a workpiece on the installation of a tool in the process of burnishing. Lathe plates of standard geometry (SNMG) were considered as tools. Modeling of contact interaction was performed in the software environment KOMPAS 3D. There are presented and analyzed the relations based on theoretical research.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.