Abstract
This paper presents the theoretical estimation method of machined surface profile without actual machining in ball-nosed end miling. The fundamental simultaneous equations of identifying the cusp height at any point of a workpiece in the simulated surface have been successfully derived from the geometric relationship between the cutting edge movement and the normal line at the point. By the numerical calculation, the machined surface profile can be estimated and illustrated graphically. It was found that the maximum and minimum cusp heights exist in a narrow range of tool orientation less than 3 degrees near the normal direction.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.