Abstract
Experimental and analytical approaches for studying the response of delaminations to in-plane compressive loads are presented. Laminates were manufactured with delaminations via an implanted thin. Teflon film. The out-of-plane displacements were monitored via shadow moire. A nonlinear, sublaminate analysis was developed using an assumed modes Rayleigh-Ritz, minimum potential energy procedure. Sublaminate growth was predicted using previously published critical Mode I interlaminar strain energy release rates ( G 1 c ) and compared to the experimental results. Good agreement was found between the analytical model and the experimental results. An important conclusion is that simple, linear sublaminate buckling models may not be adequate for predicting delimination propagation and laminate failure.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have