Abstract
We propose a novel VLSI current-mode shaping cell for high-resolution spectroscopy. This innovative topology is based on the possibility of virtually increasing the physical value of an integrated resistor thus allowing to design shaping amplifiers with high-value (/spl sim/1-10 /spl mu/s) time constants with reduced area occupancy. In this paper, we present the main issues of the circuit design and a detailed analysis of the noise performance of the proposed topology. Profiting from this current-mode approach, we have designed in 0.8-/spl mu/m BiCMOS technology a fifth-order shaping amplifier (0.5-/spl mu/s shaping time) to be coupled to monolithic arrays of silicon drift detectors (SDDs) for high-resolution X-ray spectroscopy. The measured integral-non-linearity is below /spl plusmn/0.2% and the achieved energy resolution at the Mn K/spl alpha/ line (measured with the proposed shaping amplifier coupled to a single-channel 5 mm/sup 2/ Peltier-cooled SDD) is 159 eV FWHM fully comparable to the one obtained with a commercial shaping amplifier with the same time constant.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
