The Value of Three-Dimensional Modeling on Repositioning and Soft Tissue Filling in Microsurgical Reconstruction of Secondary Mandibular Defects: A Retrospective Study.

Abstract

PurposeSecondary mandibular defect reconstruction is a challenging operation. It is performed rather rarely, as in most of the cases a primary reconstruction is preferable. Restoration of function and symmetry, in secondary reconstruction of mandibular defects, requires accurate repositioning of segments and appropriate soft tissue filling. The purpose of this study is to estimate the value of three-dimensional (3D) digital modeling to meet the above requirements, in secondary microsurgical reconstruction of mandibular defects.MethodsFive cases of mandibular defects, with various degrees of asymmetry and dysfunction, were restored secondarily, with fibula flaps, after virtual reconstruction on a 3D model derived from their computed tomography, with the utilization of CAD-CAM software. Software reproduced symmetrical 3D models by mirroring the healthy side. Occlusion was restored by fine adjustments on 3D models and finally a reconstruction plate was pre-bent on them, prior to its sterilization for use in surgery. Three out of the five cases received an osteo-cutaneous flap, while in the other two patients, an osseous flap was used. Lower face symmetry, mouth opening, and main patient’s complaints were evaluated pre- and postoperatively to assess the value of the 3D modeling.ResultsAll flaps survived. Hematoma occurred in two patients and was resolved after evacuation. In two patients, a fistula observed, was attributed to screw loosening, and treated after a surgical debridement and screw replacement. Intraoral exposure in the posterior part of the fibula flap was recorded in one patient, possibly from wound dehiscence due to tension of the intraoral tissue, and successfully covered with an ipsilateral nasolabial flap. The resulting symmetry and function were satisfactory in all the patients.ConclusionSecondary mandibular defects are often related with cosmetic disfigurement, misalignment of mandibular segments, and mandibular malfunction. For the correction of mandibular continuity, symmetry, and restoration of function, preoperative 3D modeling may be an important tool, according to our results.