Abstract
Knowledge of foliar surface area is important in many fields, but estimating the area of nonflat conifer needles is difficult. The primary goal of this study was to use optical scanning and immersion methods to test and refine the standard cross-sectional geometries assumed for black spruce (Picea mariana (Mill.) BSP) and jack pine (Pinus banksiana Lamb.) needles. Projected leaf area (PLA, measured using a flatbed scanner), and hemisurface leaf area (HSLA, estimated from water immersion) were compared for conifer samples from a 37-year-old even-aged stand in northern Manitoba, Canada. The HSLAPLA relationship was used to infer information about needle cross-sectional geometry after assuming a basic form (rhombus for black spruce and hemiellipse for jack pine). The cross section of black spruce needles was best approximated as a rhombus with a major/minor diagonal ratio of 1.35. Jack pine needles were best described by a hemiellipse with major/minor axis ratio of 1.30. Minor but incorrect assumptions of needle cross-sectional geometry resulted in foliar area errors of 68% using scanning methods and 12% using immersion methods. Simple equations are presented to calculate hemisurface needle area from volume or projected needle area based on these refined parameters.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.