Abstract
A 14C-radiorespirometric assay was used to show the sensitivity of fixed-film (sessile), catheter-associated and free-living (planktonic) cells of Pseudomonas aeruginosa to varying concentrations (100μg./mL to 1000μg./mL) tobramycin sulfate. This strain of P. aeruginosa has an MIC of 0.6μg./ml and an MBC of 50μg./mL when tested by conventional methods. When 14C-glutamic acid was used as a substrate in this radiorespirometric assay, it could be completed in less than one hour and planktonic samples showed a significant reduction in mineralization activity (evolution of 14CO2) within eight hours of the antibiotic challenge. These changes in respiratory activity appeared to be dose and time dependent. Within 18 hr. at 1000μg./mL, there was no significant residual respiratory activity in planktonic samples. Some residual respiratory activity was detected, however, in samples exposed to 100μg./mL for 36 hours. The mineralization activity of sessile catheter-associated bacteria was unaffected by four hr. and eight hr. exposures to 1000μg./mL of the antibiotic. A significant reduction in respiratory activity was recorded in catheter samples exposed for 18 hr. or more at each concentration examined. Unlike the planktonic samples, however, the antibiotic challenge failed to eradicate the metabolic activity of the attached bacteria. Antibiotic stressed, catheter-associated bacteria transferred to a post-exposure enrichment broth showed a limited ability to re-establish respiratory activity. This apparent recovery was limited to antibiotic exposures less than 24 hr. and was not observed in planktonic samples. The radioisotopic assay is a non-culture method which can be used to assess the antibiotic sensitivity of both planktonic bacteria and "in situ" biofilm populations. Clinically, it can be used to demonstrate that some adherent biofilm bacteria can survive the exposure to antibiotics that is achieved in routine chemotherapy.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have