Abstract

To evaluate the abrasivity of different toothpastes both quantitatively and qualitatively with a profilometer technique and to correlate these findings to the radioactive dentin abrasivity (RDA) value. Acrylic plates were exposed to brushing in a brushing machine with 11 different toothpastes. The results were evaluated using a profilometer. A surface roughness value (Ra-value), that is, a qualitative measurement, and also a volume value, that is, a quantitative measurement, were calculated from the profilometer results. These values were then correlated to each other and to the RDA-value. A comparison between RDA, Ra and volume measurements was performed using linear fitting procedure. The results showed that the correlation between RDA and Ra measurements was low (R(2) = 0.04) and also that the correlation between RDA and volume measurements was low (R(2) = 0.00002). Correlation between Ra and abraded volume was high (R(2) = 0.87). It is important to consider not only the RDA-value when evaluating toothpaste abrasivity. From the profilometer results both a quantitative (volume) and qualitative (roughness) measurement of the abrasivity of a toothpaste can be obtained.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.