Abstract
A dead-end ultrafiltration cup was continuously operated to investigate the underlying mechanisms of membrane fouling caused by gel layer in this paper. Anionic polyacrylamide was used as a model foulant for gel formation process in various ultrafiltration processes by two kinds of ultrafiltration membrane, e.g., polyvinylidene fluoride (PVDF) membrane (OM) and TiO2/Al2O3-PVDF membrane (MM); then, a gel formation model was established and systematically assessed. The results show that the gel formation process in ultrafiltration can be divided into three stages: "slow-rapid-slow" flux decay curve. The R2 value of the simulation curve was still higher than 0.90 for both OM and MM. Based on the current cognition, the proposed gel layer formation mechanism and mathematical model were feasible.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Environmental science and pollution research international
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
