The tertiary creep of polycrystalline ice: experimental evidence for stress-dependent levels of strain-rate enhancement

Abstract

AbstractLaboratory creep deformation experiments have been conducted on initially isotropic laboratory-made samples of polycrystalline ice. Steady-state tertiary creep rates, , were determined at strains exceeding 10% in either uniaxial-compression or simple-shear experiments. Isotropic minimum strain rates, , determined at ˜1 % strain, provide a reference for comparing the relative magnitude of tertiary creep rates in shear and compression through the use of strain-rate enhancement factors, E, defined as the ratio of corresponding tertiary and isotropic minimum creep rates, i.e. . The magnitude of strain-rate enhancement in simple shear was found to exceed that in uniaxial compression by a constant factor of 2.3. Results of experiments conducted at octahedral shear stresses of to = 0.040.80 MPa indicate a creep power-law stress exponent of n = 3 for isotropic minimum creep rates and n = 3.5 for tertiary creep rates. The difference in stress exponents for minimum and tertiary creep regimes can be interpreted as a t0 stress-dependent level of strain-rate enhancement, i.e. .The implications of these results for deformation in complex multicomponent stress configurations and at stresses below those used in the current experiments are discussed.