Abstract
Injection molding is used in various fields. Surface properties are an important subject and there are many reports on them. From the viewpoints of cost and productivity, the injection molding of multi-cavity injection die is used widely. However, there is no report on the research of surface properties in these injection moldings.In this study, we observed surface state and measured surface roughness for the injection molding with emboss form on the surface and compared with surface state about molding conditions. Moreover, we carried out the optimization of runner design in consideration of simultaneous filling using injection molding flow analysis and considered the influence of runner balance on the surface state. High mold temperature improves surface properties for the whole injection molding. Short filling time improves surface properties for the portions do not require much packing pressure. The optimized runner balance can realize uniform surface properties in multi cavity injection die.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
