Abstract
The article presents information on model plastics presented on the market of the Republic of Belarus. The analysis of methods for creating accurate model sets using both 3D printing from thread and granules, and obtaining model sets from an array of model plastic using 3D milling is carried out. The properties were evaluated and the behavior of glued and solid plastics under compressive loads in the longitudinal and transverse directions was shown. Economic efficiency assessment of various methods of obtaining model sets is given, based on a comparison of the cost of materials and the production process itself.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Litiyo i Metallurgiya (FOUNDRY PRODUCTION AND METALLURGY)
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
