Abstract
Protein-loaded microparticles were produced from blends of poly(ethylene glycol) (PEG) with poly( l-lactide) (PLA) homopolymer or poly( dl-lactide co-glycolide) copolymers (PLG) using a water-in oil-in oil method. The stability of ovalbumin (OVA) associated with microparticles prepared using PEG and 50:50 PLG, 75:25 PLG and PLA, respectively, was analysed by SDS-PAGE and quantified by scanning densitometry following incubation in PBS at 37°C for up to 1 month. Fragmentation and aggregation of OVA was detected with all 3 formulations. The extent of both processes correlated with the degradation rate of the lactide polymer used and decreased in the order PLA<75:25 PLG<50:50 PLG. Extensive degradation of the PLG/PEG microparticles also occurred over 4 weeks whereas the use of PLA/PEG blends resulted in a stable microparticle morphology and much reduced fragmentation and aggregation of the associated protein. Following a single sub-cutaneous immunisation, high levels of specific serum IgG antibody were elicited by OVA associated with the PLA/PEG particles. Injection of OVA associated with the 75:25 PLG/PEG microparticles resulted in very low levels of specific antibody. A higher response was induced by the 50:50 PLG/PEG formulation but there was very large inter-animal variation in this group. Antibody levels elicited by all 3 formulations were significantly higher than those elicited by a single injection of soluble OVA. Analysis of antigen specific IgG1 and IgG2a antibody subtype levels also revealed the greater efficacy of the PLA/PEG microparticles as an adjuvant system. The use of PLA/PEG microparticles shows improved protein loading and delivery capacity while maintaining a high level of stability of the associated protein. These results indicate a strong correlation between the stability of microencapsulated antigen and the magnitude of the immune response following sub-cutaneous immunisation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.