The spark plug’s thermal state simulation

Abstract

BACKGROUND: Spark plugs are among the most important components of the ignition system of an internal combustion engine (ICE). The spark-over produced by the ignition system should have sufficient energy for combustion initiation at any engine operation mode in all the service conditions. Start properties, reliability, power, fuel efficiency and exhaust toxicity of an ICE essentially depend on excellence of design and manufacturing quality of a spark plug. On the other hand, functional properties of spark plugs depend on concordance to ICE with main dimensions, design, heat properties and value of a spark gap. AIMS: Use of the methods of the spark plugs temperature field simulation in order to reduce the amount of experimental studies and to reduce the number of specimen options subjected to laboratory and on-road engine tests.
 METHODS: The simulation model of the temperature field of a spark plug of an internal combustion engine (ICE) was developed in this study.
 RESULTS: The representation of temperature distribution in the insulators thermal cone and other ceramic elements of a spark plug was obtained. The dependence of thermal conductivity and specific thermal capacity of corundum ceramics on temperature was derived. The dependencies of thermal conductivity coefficient of the plugs ceramic insulator are presented. The analysis of thermophysical properties of the substances made of various materials was carried out. The equations of the temperature field of all parts of a spark plug (a contact head, glass sealant, an insulator, a central electrode, a spark plugs body, a heat-sinking washer, a sealing ring, a cylinder head) were developed. The schematic representation of the spark plug geometry, used in the temperature field calculation, was obtained. The requirements for boundary conditions for calculation of the temperature field of a spark plug were determined. The calculation scheme of the spark plug is presented. The condition of heat exchange at the boundary between the selected part of a cylinder head and the cooling system of an internal combustion engine was considered. The study of heat transfer between the structural elements of a spark plug and the air inside the ICE compartment was carried out. The dependencies describing the heat exchange between the structural elements of a spark plug being in thermal contact with each other were determined and the internal boundary conditions were established.
 CONCLUSIONS: The presented methods and algorithms of spark plugs thermal state simulation helped to perform the calculation of dependencies of thermal conductivity and specific thermal capacity of the insulators ceramics as well as the thermal conductivity coefficient of the plugs ceramic elements on temperature.