Abstract
The aim of this article is to present possibilities of diffusion bonding utilization at creation heterogeneous joints where strength properties are taken into account. The joint was implemented to low-alloy structural ferrite-pearlite S355J2 steel and high-alloy austenitic AISI 316L steel. The fundamental theory of diffusion and also design and realisation of experimental creation of diffusion joint in thermal-mechanical simulator Gleeble 3500 is described in the article. Furthermore, procedure of technological parameters selection, when optimisation of strength properties of heterogeneous joint including metallographic evaluation are taken into account, are presented.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
