The science of making more torque from wind: Diffuser experiments and theory revisited.

Abstract

History of the development of DAWT's stretches a period of more than 50 years. So far without any commercial success. In the initial years of development the conversion process was not understood very well. Experimentalists strived at maximising the pressure drop over the rotor disk, but lacked theoretical insight into optimising the performance. Increasing the diffuser area as well as the negative back pressure at the diffuser exit was found profitable in the experiments. Claims were made that performance augmentations with a factor of 4 or more were feasible, but these claims were not confirmed experimentally. With a simple momentum theory, developed along the lines of momentum theory for bare windturbines, it was shown that power augmentation is proportional to the mass flow increase generated at the nozzle of the DAWT. Such mass flow augmentation can be achieved through two basic principles: increase in the diffuser exit ratio and/or by decreasing the negative back pressure at the exit. The theory predicts an optimal pressure drop of 8/9 equal to the pressure drop for bare windturbines independent from the mass flow augmentation obtained. The maximum amount of energy that can be extracted per unit of volume with a DAWT is also the same as for a bare wind turbine. Performance predictions with this theory show good agreement with a CFD calculation. Comparison with a large amount of experimental data found in literature shows that in practice power augmentation factors above 3 have never been achieved. Referred to rotor power coefficients values of CP,rotort= 2.5 might be achievable according to theory, but to the cost of fairly large diffuser area ratio's, typically values of β>4.5.