The role of the European centre for the validation of alternative methods (ECVAM) in the validation of (Q)SARs

Abstract

Under the current chemicals legislation, the regulatory use of structure-activity relationships (SARs) and quantitative structure-activity relationships (QSARs), collectively referred to as (Q)SARs, for the assessment of chemicals is limited, partly due to concerns about the extent to which (Q)SAR estimates can be relied upon. On 29 October 2003, the European Commission adopted a legislative proposal that foresees the introduction of a new regulatory system for chemicals called REACH (Registration, Evaluation, and Authorisation of Chemicals), which will impose equivalent information requirements on both new and existing chemicals. For reasons of practicality, cost-effectiveness and animal welfare, it is envisaged that (Q)SARs will play an important role in the assessment of some 30,000 existing chemicals for which further information may be required under the REACH system. It will therefore be essential that the (Q)SAR models used will produce reliable estimates. To overcome the barriers in the acceptance of (Q)SARs for regulatory purposes, it is widely acknowledged that there needs to be international agreement on the principles of (Q)SAR validation, and that the process of (Q)SAR validation should be managed by independent organisations, with a view to providing independent advice to the regulators who make decisions on the acceptability of (Q)SARs. The European Centre for the Validation of Alternative Methods (ECVAM), which is part of the European Commission's Joint Research Centre (JRC), has a well-established role in providing independent scientific and technical advice to European policy makers. This paper describes progress made at an international level regarding the principles of validation, and explains the role of ECVAM regarding the practical validation of (Q)SARs.