Abstract
Blends of isotactic polypropylene (iPP) and polycarbonate (PC) with and without a compatibilizer were prepared using a Brabender Haake Rheocord at 260°C and 32 rpm. Maleic anhydride grafted styrene-ethylene/butylene-styrene (SEBS-g-MAH) and maleic anhydride grafted ethylene–propylene diene (EPDM-g-MAH) were chosen as compatibilizers and their proportion was set to 5, 10, and 15 wt%, respectively. The thermal properties and crystallization behavior were determined by differential scanning calorimetry (DSC) and wide angle X-ray scattering (WAXS). Micromechanical properties were also investigated using a Vickers microindentation tester. The DSC analysis indicates that the melting temperature of iPP in the all the blends, compatibilized and uncompatibilized ones, remains constant and is almost the same as those of the pure component. On the other hand, it is shown that the degree of crystallinity of iPP in the blends calculated by DSC and WAXS is dependent of the composition of the polymeric mixture. However the hardness (H) decreases with increasing PC content until the composition of iPP/PC (75/25) is reached, whereas for larger PC content values, H increases. The same trend was obtained with the addition of both compatibilizers. POLYM. ENG. SCI., 2016. © 2016 Society of Plastics Engineers
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
