Abstract
We compared the phase change behavior of a partially wetting fluid, nonane, on various SiO2 surfaces that had been modified to alter their roughness at the nanoscale. We compared a total of four surfaces: an as-received, smooth surface; a surface roughened by plasma-enhanced chemical vapor deposition (PECVD) of SiO2; and two surfaces where SiO2 nanorods had been deposited using glancing angle deposition (GLAD). Scanning electron microscopy (SEM) and atomic force microscopy (AFM) were used to characterize the surfaces. The topography of the rough surface controlled the wetting characteristics of the fluid that in turn, controlled the change-of-phase heat transfer rate. The measured apparent contact angle characterized the wetting property during the phase change process. Surface roughness promoted wetting in this system, but the direction of heat transfer controlled the topographic design required for enhanced performance. A comparison between two nanorod coatings of differing heights shows that the longer nanorod coating (30 nm high) acted somewhat like a porous surface promoting condensation heat transfer while the shorter nanorod coating (10 nm high) was much more effective at promoting evaporative heat transfer. Surface alteration at the scale over which intermolecular forces dominates the fluid-solid interaction provides a convenient means for probing those interactions.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.