Abstract

Graded multi-material parts achieve a compositionally graded transition between two different materials, mitigating undesirable consequences such as cracking and delamination due to property mismatch and significantly improving the comprehensive performance of parts. In this study, the Ti6Al4V/AlMgScZr-graded multi-material parts were fabricated using laser powder bed fusion technology, introducing a composition-graded layer with 25 wt.% Ti6Al4V and 75 wt.% AlMgScZr at the interface to reduce the mismatch between the two materials. The effect of the graded layer’s laser scanning speed on the densification behavior, microstructure evolution, and mechanical properties of the Ti6Al4V/AlMgScZr-graded multi-material parts was investigated. It was revealed that the crack area at the interface reduced from 0.325 to 0.067 mm2 as the scanning speed increased from 2400 to 2800 mm/s and then increased to 0.161 mm2 at 3000 mm/s. A smooth, continuous-graded layer with good metallurgical bonding was fabricated at 2800 mm/s. The TiAl3 intermetallic compound was formed at the interface and underwent a transition from rod-like to coarse dendritic and finally to finer dendritic structure along the building direction. The Ti6Al4V/AlMgScZr-graded multi-material parts exhibited a graded decrease in microhardness from 374 HV0.2 on the Ti6Al4V side to 122 HV0.2 on the AlMgScZr side, and an excellent compressive strength of 1531 MPa was obtained at the optimal parameter of 2800 mm/s.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call