Abstract
Selective laser sintering, also called laser sintering (LS), is an additive manufacturing process that requires micronized plastic powder. Recently, we showed poly (ethylene terephthalate (PET) powder is a suitable material for LS, with a comparable printing performance as the current front-runner, polyamide 12 (PA12). However, the LS process, by its nature, leaves unused powder that has been exposed to heat for prolonged time, and this powder may not be fully re-usable due to degradation.In this work, the re-use potential of heat-exposed PET powder is established. This is a matter of crucial importance as powders suitable for LS are very expensive, and the powder left after a building episode has to be re-used. Heat-exposed PA12 has to be blended or refreshed with virgin powder, to avoid printing defects. In contrast, heat-exposed PET powder, after 96 h at 210 °C, could be used, without refreshing with a portion of virgin powder. The printed articles from heat-exposed powders were as good as those from the fresh powder. There was no cross-linking and there was only a minor increase in the molecular weight of the powder after 96 h, at 210 °C.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
