The Retention of Cast Metal Dowels Fabricated by Direct and Indirect Techniques

Abstract

To explore the effect of fabrication technique, cement type, and cementation procedure on retention of cast metal dowels. Eighty intact single-rooted teeth were selected. The clinical crown was removed at the cementoenamel junction level. Each root was prepared to receive a cast metal dowel of 10-mm length and 1.45 mm in diameter. The 80 specimens were divided into two major groups of 40 based on fabrication technique (direct and indirect). Each group was further divided into four subgroups of ten based on the cement type (zinc phosphate and glass ionomer), and cementation procedure (with and without lentulo spiral). The dowels were subjected to a constantly increasing tensile force, in a universal Instron testing machine, at crosshead speed of 5 mm/min until failure. The most significant factor to affect retention was the cementation procedure, as cementation with lentulo spiral produced greater retention than cementation without the use of lentulo spiral (p < 0.05); however, there seems to be a close interaction between fabrication technique, cement type, and cementation procedure (p= 0.051). The least retentive group was the one fabricated by direct technique, cemented with zinc phosphate without the use of lentulo spiral. Fabrication technique does not affect retention of cast dowels, except when zinc phosphate was the luting agent and placed in the canal space without using a lentulo spiral. The cementation procedure had a significant effect on retention; thus, it is recommended that cementation should be done using the lentulo spiral.