Abstract
A systematic cutting test was conducted turning normalized AISI1045 carbon steel with two kinds of Ti (C, N)-based cermet cutters, which were made with micron and nanometer TiC powders. And the cutting performance and abrasion mechanism was discussed in the article. The effect of tool orthogonal clearance on tool life was also researched in this paper. Results showed that: The tool life was affected seriously by tool orthogonal clearance angle, and the optimum tool orthogonal clearance angle of Ti (C, N)-based cermet cutter was 5°when cutting normalized AISI1045 steel. The cutting Performance of Ti (C, N)-based cermet cutters which were made with nanoTiC powders was better than the ones which were made with micron TiC powders obviously. And the primary wear behaviors were wear.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.