The repeatability of friction and wear results obtained from unlubricated reciprocating sliding tests

Abstract

AbstractLaboratory tests can help in the analysis of tribological failures of elements, and improve tribo‐systems by choosing appropriate materials. In order to characterise the friction and wear behaviour of candidate materials, various different test methods have been developed in the past and are still in use. One such method is the reciprocating sliding of a ball against a disc.In the work reported here, the repeatability of friction and wear results was evaluated with ten tests under identical conditions with a steel (100Cr6) or alumina (Al2O3) ball against a steel (100Cr6) disc under unlubricated conditions at room temperature. The influence of ambient humidity on friction and wear behaviour was determined in three additional tests in dry and in moist air, respectively. The repeatability of friction coefficient in normal air was better than 5% for alumina/100Cr6 and 12% for 100Cr6/100Cr6, while the repeatability of volumetric wear was slightly better than 10% for alumina/steel, and slightly worse than 10% for steel/steel.For both couples the coefficient of friction is lowest in moist air and about 50% higher in dry air. The coefficient of wear is also least in moist air and higher by a factor of 3(5) in dry air for tests with a 100Cr6 (alumina) ball.