The reciprocal effects of bending and torsion on springback during 3D bending of profiles

Abstract

Abstract Profiles with circular cross-sections can be geometrically described by the shape of the bending line. To achieve 3D bending lines with kinematic bending processes, a continuous change of the bending plane is needed, resulting in bending force vectors that change in direction accordingly. These force vectors generate a bending moment in the forming zone and, thus, longitudinal tensile and compressive stresses. For profiles with non-circular cross-sections, the orientation of the cross-section along the bending line needs to be additionally controlled. This can be achieved by applying a specific torque to the bending process and, thus, introducing desired shear stresses into the forming zone. Up until now, this fundamental aspect of 3D profile bending has not been regarded in a coherent fashion. To take into account the reciprocal effects of the stresses applied to the forming zone and their effect on the bending moment and, thus, on springback, a comprehensive analytical process model was set up. The model is validated by experimental investigations performed using the TSS profile bending machine and comprehensive numerical investigations. Analyses were performed during plane bending as well as bending superposed with torsion. The investigations show that the applied bending force and torque not only result in stress superposition but actually also affect the development of shear strains over the cross-section of the profile. Similar to the longitudinal strains, the shear strains decrease linearly from the intrados and extrados of the profile to the neutral axis. Considering this newly observed behavior in the analytical process model, the bending moment prediction is in accordance with the experimental and numerical results.