The rapid life of Arctic sea-ice ridge consolidation and melt

Abstract

In this study, we cover observations of the rapid consolidation and enhanced melt of Arctic sea-ice ridges. During the freezing period, the consolidated part of sea ice ridges is usually up to 1.6–1.8 times thicker than surrounding level ice. Meanwhile, during the melt season, ridges are often observed to be fully consolidated, but this process is not fully understood. We present the evolution of the morphology and temperature of a first-year ice ridge studied during MOSAiC from its formation to advanced melt. From October to May, the draft of first-year ice at the MOSAiC coring site increased from 0.3 m to 1.5 m, while from January to July, the consolidated layer thickness in the ridge reached 3.9 m. We observed several types of ridge consolidation. From the beginning of January until mid-April, the ridge consolidated slowly through heat loss to the atmosphere, with a total consolidated layer growth of 0.7 m. From mid-April to mid-June, there was a rapid increase in ridge consolidation rates, despite conductive heat fluxes not increasing. In this period, the mean thickness of the consolidated layer increased by 2.2 m. We also estimated a substantial snow mass fraction (6%–11%) of ridges using analysis of oxygen isotope composition. Our observations suggest that this sudden change was related to the transport of snow-slush inside the ridge keel via adjacent open leads that decreased ridge macroporosity, which could result in more rapid consolidation. During the summer season, sea ice melts from the surface and bottom. The melt rates substantially vary for sea ice ridges and undeformed first- and second-year ice. Ridges generally melt faster than undeformed ice, while the melt of ridge keels is often accompanied by further summer growth of their consolidated layer, which increases their survivability. We examined the spatial variability of ice melt for different types of ice from in situ drilling, coring, and multibeam sonar scans of the remotely operated underwater vehicle. Six sonar scans performed from 24 June to 21 July were analyzed and validated using seven ice drilling transects. The area investigated by the sonar (0.4 km by 0.2 km) consisted of several ice ridges, surrounded by first- and second-year ice. We show a substantial difference in melt rates for sea ice with a different draft. We also show how ridge keels decay depending on the keel draft, width, steepness, and location relative to the surrounding ridge keel edges. We also use temperature buoy data to distinguish snow, ice surface, and bottom melt rates for both ridges and level ice. These results are important for quantifying ocean heat fluxes for different types of ice during the advanced melt and for estimating the ridge contribution to the total ice mass and summer meltwater balances of the Arctic Ocean.