Abstract

Colloid-facilitated transport of contaminants could enhance the release rate of radionuclides from the cementitious near field of a repository for radioactive waste. In the current design of the planned Swiss repository for intermediate-level radioactive waste, a gas-permeable mortar is employed as backfill material for the engineered barrier. The main components of the material are hardened cement paste (HCP) and quartz aggregates. The chemical condition in the backfill mortar is controlled by the highly alkaline cement pore water present in the large pore space. The interaction of pore water with the quartz aggregates is expected to be the main source for colloids. Colloid transport is facilitated due to the high porosity of the backfill mortar. Batch-type studies have been performed to generate colloidal material in systems containing crushed backfill mortar or quartz in contact with artificial cement pore water (ACW) at pH 13.3. The chemical composition of the colloidal material corresponds to that of calcium silicate hydrates (CSH). Batch flocculation tests show that, after about 20 days reaction time, the concentration of the CSH-type colloids is typically below 0.1 mg l −1 due to reduced colloid stability in ACW. Uptake studies with Cs(I), Sr(II) and Th(IV) on a CSH phase (initial C:S ratio=1.09) have been carried out to assess the sorption properties of the colloidal material. The influence of uptake by colloids on radionuclide mobilisation is expressed in terms of sorption reduction on the immobile phase (HCP). Sorption reduction factors can be estimated on the assumption that the sorption properties of the colloidal material are either similar to those of the CSH phase or HCP, and that sorption is linear and reversible. A scaling factor accounts for the higher specific surface area of the colloidal material compared to the CSH phase and HCP. At colloid concentration levels typically encountered in highly alkaline cement pore waters, colloid-induced sorption reduction is predicted to be negligibly small even for strongly sorbing radionuclides, such as Th(IV). Thus, no significant impact of cementitious colloids on radionuclide mobilisation in the porous backfill mortar is anticipated.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call