Abstract
Zn is utilized as an anode in alkaline batteries because of its propensity to produce a passive colloidal layer on its surface. Then the surface should be reactivated in the passive region. Therefore, the passive state on the surface can be significantly hindered by utilizing a tiny percentage of Sb alloyed with Zn. Accordingly, the effect of minor Sb alloying with Zn on the performance of anodic dissolution and passivation in concentrated alkaline media (6 M KOH, which is used in the batteries) was studied using potentiodynamic and potentiostatic techniques. Besides, the passive layers formed at various anodic potentials were characterized utilizing scanning electron microscopy (SEM) and X-ray diffraction (XRD). The data of potentiodynamic measurements exhibited the active–passive transition curve of all studied specimens. All obtained results revealed that passivation is gradually hindered with increasing Sb content in the alloy, and less passivity was obtained at 1% Sb. Along this, a dramatic rise in current density at a particular positive potential (+ 2.0 V vs. SCE) to markedly higher values only of the electrodes containing Sb is observed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.