The occurrences and mobility of shale oil in the pore space of terrestrial shale

Abstract

Movable oil, the critical factor for shale oil enrichment and effective production, is influenced by the pore structure and shale oil occurrence state. However, the pore spaces storing movable oil, the occurrence state of shale oil, and the lower flowing pore size for shale oil remained unclear. To address this knowledge gap, we chose the lacustrine organic-rich Chang7 shale of the Ordos Basin as the research target. By combining gas adsorption techniques (nitrogen and carbon dioxide) with Soxhlet Extraction, we investigated the pore structure alteration of Chang7 shale after Soxhlet Extraction. Based on a comprehensive analysis of mineralogical composition, TOC, and shale oil components, we discussed the pore space in which shale oil exists. Then, we established a slit-shaped clay model and clarified the occurrence state of multi-component shale oil in the pore space with the help of molecular simulation. Our investigation revealed that (1) Chang7 shale can be categorized into three distinct types. Type I, characterized by a high clay mineral content, possesses the greatest SSA and PV and has the highest abundance of movable oil, partially filling the “ink-bottle”-type pores. Shale oil in Type II and III shales mainly exists within slit-type pores. (2) The pore space of Chang7 shale is primarily comprised of mesopores rather than micropores. Moreover, mesopores’ PV and SSA are predominantly governed by clay minerals rather than organic matter. (3) A threshold pore size of 10 nm significantly impacts the occurrence state of shale oil in the Chang7 shale. Beyond this threshold, free oil accounts for over 80% of the total. Chang7 shale oil within micropores (<2 nm) is predominantly asphaltene, existing in an adsorbed state. Within pores sized 2 to 10 nm, shale oil is present in both adsorbed and free states, and the proportion of free-state shale oil increases with the pore size. Free-state shale oil prevails in pores exceeding 10 nm, with a smaller fraction adsorbed onto organic matter and mineral surfaces. Thus, we recommend adopting 10 nm as the lower flowing pore size limit for Chang7 shale.