Abstract
Unmanned aerial vehicles (UAVs) are at the forefront of this century’s technological shift, becoming ubiquitous in research and market areas. However, as a UAV navigates autonomously, there are unanticipated occasions, e.g., collisions with dynamic obstacles or loss of data provided by the global navigation satellite system (GNSS), where the aircraft has to change its mission plans. In particular, to be protected from possible accidents, the platform’s geofence protection system should adjust the trajectory appropriately when obstacles are detected and select the proper ground surface when emergency landing is prompted. As these processes require fast reaction times, utilizing low latency sensors and algorithms is necessary. This article proposes a complete and low-complexity geofence protection system for recognizing moving objects and assessing the ground surface’s suitability using onboard sensing and processing modules. The proposed system is implemented on a novel fixed-wing UAV, designated as MPU RX-4, which features an unconventional flying wing layout and vertical take-off and landing (VTOL) capabilities. Our system is based on a forward-facing laser imaging, detection, and ranging (LIDAR) sensor and three downward-facing laser rangefinders. We take advantage of the high-precision distance measurements and operational speed to identify moving obstacles using the LIDAR module, while the ground’s slope and the existence of any obstacle therein are computed through the rangefinders. First, the article describes the UAV design procedure and its aerodynamic performance characteristics, which allowed us to evaluate our approach on a testbed aircraft. Then, the evaluation protocol shows that our system can perform robustly and under real-time constraints reaching an overall latency of only 165.5 ms, sufficient for reliable detection and avoidance of moving obstacles.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Instrumentation and Measurement
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
