The microstructure and corrosion behavior of Cr-containing ferrite-pearlite steels in an acidic environment

Abstract

PurposeThe poor corrosion resistance of the ferrite-pearlite steel limits its application in marine engineering because of the enhanced galvanic effect caused by continuously accumulated cementite. Cr as one principal alloying element is commonly used to improve the corrosion resistance of steels. This paper aims to study the effect of Cr on corrosion behaviors of ferrite-pearlite steels in an acidic environment.Design/methodology/approachThe tested steels were immersed in a simulated solution of 10 Wt.% NaCl with pH 0.85 for 72 h to evaluate the corrosion rate. After the immersion test, the corrosion morphologies and products were tested by scanning electron microscopy, energy dispersive X-ray analysis and X-ray diffraction. Meanwhile, an electrochemical workstation was used to study the electrochemical behaviors of samples.FindingsAt the initial corrosion stage, the corrosion rate increased in the sequence of Cr0, Cr0.5 and Cr1 steels, which was because of the competitive effect between the area ratio and the driving force caused by alloyed Cr. However, Cr1 steel exhibited the best corrosion resistance after a 72-h immersion test. This was because the alloyed Cr promoted the formation of protective Fe2O3 and FeCr2O4, which suppressed the preferential dissolution of ferrite and, thus, reduced the accumulation rate of carbides, resulting in the weakened galvanic corrosion.Originality/valueThis paper reports the role that Cr plays in the galvanic corrosion of ferrite-pearlite steels, which is important for the engineering application of ferrite-pearlite steels in marine environment.