Abstract
Fatigue tests and measurements of the volumetric distribution of metallurgical hydrogen in specimens cut from rolled I-beam 60Sh3 made of steel 10KhSND were carried out. Fatigue tests show a 20% reduction in fatigue limits compared to similar sheet material. On the fractures of the samples, there are flock-like defects in the areas of interface of the flanges of the I-beam, or the so-called zones of difficult deformation. The concentration of metallurgical hydrogen is unevenly distributed and varies from 0.17 ppm to 1.8 ppm. Large concentrations of hydrogen are observed in the zones of difficult deformation, which indicates the hydrogen nature of the metal defects observed at the fracture. The result of mechanical tests and hydrogen diagnostics is a manufacturing defect of rolled products that cannot be corrected. Hydrogen diagnostics using metallurgical hydrogen (without hydrogen charging samples) takes tens of times less time than mechanical tests, and gives an adequate result.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
