Abstract
The Madden-Julian oscillation (MJO) simulated by the Canadian Climate Centre general circulation model (CCC GCM) is identified by a principal oscillation pattern (POP) analysis and compared with that observed in the real atmosphere. The results are based upon two integrations of the CCC GCM, one with a parameterization of penetrative cumulus convection (EXP1) and the other with a moist convective adjustment scheme (EXP2). The signal of MJO can be detected in both integrations as the first POP of the 200 hPa velocity potential along the equator. The disturbances show a distinctive wave number one structure with the strongest local amplitude found in the longitudes corresponding to the region of the Asian monsoon. The phase speed of the eastward wave propagation is higher in the eastern Pacific and lower in the monsoon region where the convective activities are strongest. These features are in good agreement with the observations. The energy spectrum of the velocity potential peaks at the frequency corresponding to a period of about 38 days for EXP1, which is somewhat shorter compared to the observed periods of 40–50 days. On the other hand, two spectral peaks can be clearly identified for EXP2, one with a period of 24 days and the other with a much longer period, somewhere near 112 days. Both peaks appear statistically significant at 95% level. Long term data of the observed atmosphere show little indication of such spectral separation. The horizontal patterns identified by the POP analysis resemble to some extent the baroclinic response of tropical flow to a heat source travelling with the speed of MJO. At the upper level, Rossby wave energy propagates westward with winds generally following the height contours, whereas Kelvin wave energy propagates to the east from the heat source with strong cross-contour flow near the equator. At the lower level, the patterns are essentially reversed. The model-generated precipitation and diabatic heating are examined by compositing against the moving MJO. It is found in EXP2 that the composite heating distribution is coherent with the flow pattern only in a certain sector of the equator, depending on whether the fast or slow mode is used to determine the reference point. The composite vertical heating profile of a slower mode tends to have a maximum found at a lower level. The sensitivity of simulated MJO to the cumulus convection scheme in the model is discussed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.