The lowest point of fibula (LPF) could be used as a reliable bony landmark for arthroscopic anchor placement of lateral ankle ligaments ----compared with open Broström procedure

Abstract

BackgroundArthroscopic technique procedures was wide accepted for the treatment of chronic ankle instability (CAI). But little acknowledge was involved to the bony landmarks and anatomic features of different bundles of lateral ligaments under arthroscopic view.MethodsSixty patients with acute or chronic lateral ankle ligaments injury (LAI) were collected prospectively, and divided randomly into two groups. In arthroscopic group, the bone tunnels were made on the LPF arthroscopically. And in open group, the bone tunnels were made on the Fibular obscure tubercle (FOT) in open procedure. The inferior bundle of ATFL and Arcuate fibre was also identified reference to the LPF and labeled by a PDS II suture penetration. Following that, The distances of the bone tunnels to the different bony markers were measured and compare between two groups. The penetrating locations of PDS II on the inferior bundle of ATFL and Arcuate fibre were also confirmed intraoperatively. And the safe angle of anchor implantation on the axial view was measured on postoperative CT scan.ResultsThe distances of bone tunnel to the fibular tip, the fibular insertion of anterior-inferior tibiofibular ligament (AITFL), and the FOT in arthroscopic and open locating groups were 4.9 ± 2.2 and 6.3 ± 2.2 mm, 13.5 ± 2.7 and 12.4 ± 1.1 mm, 5.8 ± 2.2 and 5.6 ± 1.0 mm, respectively. The distances of bone tunnels to the FOT and fibular tip on 3d-CT view was 4.4 ± 1.5 and 4.6 ± 0.9 mm, 14.4 ± 3.2 and 13.2 ± 1.8 mm in arthroscopic and open group, and there were no significant differences between two groups. The safe angle of arthroscopic anchor placement on the axial plan was ranged from 24.9 ± 6.3o to 58.1 ± 8.0o. The PDS II sutures penetrating on the inferior bundles of ATFL and the arciform fibres were also comfirmed successfully by open visualizaion.The average distance of penetration point to the horizontal line cross the fibular tip was 2.3 ± 2.7 mm (ranged from − 3.1 to 6.0 mm), and to the vertical line cross the FOT was 2.7 ± 2.7 mm (ranged from − 2.5 to 7.5 mm).ConclusionTake the lowest point of fibula under arthroscopy (LPF) as a bony reference, we could identify the iATFL under arthroscopic visualization. By this way, we could place the suture anchors properly to the fibular footprint and suture the iATFL fibres successfully.