Abstract
1. The long-term strength of polygonized aluminum at 100°C depends on the subgrain size and on the dislocation density within the subgrains, while that of the recrystallized metal depends on the grain size: The long-term strength of aluminum increases (at least for lives up to 1000h) with reduction in the grain or subgrain size and with increase in the density of internal dislocations. 2. The rate of loss of strength (the tangent of the angle of slope of the long-term strength curves) decreases with increase in the grain or subgrain size of aluminum; this leads to the convergence of the long-term strength curves of metal with different subgrains (or grains) at long lives. 3. An analogy has been found between the behavior of polygonized and recrystallized in long-term strength tests at relatively short times to failure and that in short-term tensile tests.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.