Abstract
High-dose neutron irradiation could produce various kinds of microstructural defects, and the radiation resistance of nickel alloy is put forward for higher requirements under the high temperature. To simulate the (n, α) reaction, helium ions with an energy of 540 keV were implanted into nickel-based alloy 617 at 700 °C. The microstructure and mechanical properties were established by comparing the nanoindentation hardness before and after irradiation. For the low dose irradiation, the microstrain induced by vacancy-type defects like He-vacancy clusters and helium bubbles is slight, which would not result in a large increase of hardness. The hardening effect of high-temperature irradiation was much lower than that of room-temperature irradiation due to the recovery of matrix defects. The actual distribution of helium bubbles observed by Transmission Electron Microscope (TEM) was comparable to the SRIM simulation result. The helium bubbles were spherical near the surface of the alloy and polyhedral deeper in the matrix. Moreover, chromium carbide had a strong trapping effect on helium bubbles. The shapes and distribution of the helium bubbles were analyzed to evaluate irradiation effects on nickel-based alloys.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
