Abstract
A Spiral Grooved Self-acting Gas Thrust Collar Bearing, which has high wear resistance is investigated. This thrust bearing has a washer made of hard, wear resistive material at its most inner part, and the surface of this washer stands out from the surface of the other part of the bearing, so that contact with the rotor at the start/stop of rotation occurs only on the surface of the washer. This bearing is also designed for take-off and landing at low rotational velocity to prevent wear. Here, thee design method of this bearing is presented. Also measured are the load-floating height characteristics and the floating height-rotation characteristics. These measured results are compared with theoretical predictions.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
