The influence of ultraviolet irradiation on sandblasted and acid-etching surface adsorbing human fibronectin

Abstract

To study the influence of ultraviolet (UV) irradiation on physical and chemical properties of sandblasted and acid-etched (SA) titanium surface and their ability to adsorb human fibronectin (HFn). SA and UV-SA surfaces were separately prepared. Surface morphology, roughness, elemental composition, wettability and HFn adsorption assay were performed for comparative analysis of these two surfaces. SA and UV-SA surface had a similar morphology with multi-holes, and average roughness. UV-SA surface had a lower C content (22.83%) and higher O content (51.20%) and presented hydrophilicity, while SA surface showed hydrophobicity. But the quantity of adsorbed HFn on SA surface at 10 min assay point [(0.41 ± 0.07) µg] was statistically higher than that on UV-SA surface [(0.26 ± 0.08) µg](P = 0.007). UV irradiation would not change the morphology and roughness of SA surface. However, it could reduce the hydrocarbon and increase the hydroxyl groups, and the absorption of HFn on UV-SA surface at 10 min assay point was statistically lower than that on SA surface. Therefore, the in-vitro bioactivity of UV-SA surface was not as good as that of SA surface.