The influence of the shoulder depth on the properties of the thin sheet joint made by FSW technology

Abstract

PurposeThis paper aims to experimentally determine the influence of the tool shoulder depth value on the structural and strength properties of the single lap joints made of 7075-T6 aluminium alloy made with friction stir welding (FSW) technology. The aim of the preliminary tests is to optimize the parameters of joining process of thin-walled structures such as the skin-stringer joint or skin-frame joint of the aircraft fuselage. The tests were carried out for materials commonly used in such structures, i.e. 1.6 mm thick sheet 7075–T6 aluminium alloy with cladding on both sides (cladding thickness 4% per each side). The layer of clad protects plates from corrosion.Design/methodology/approachThis study shows the results of the investigation for the joining of 7075–T6 ALCLAD aluminium alloy sheets. The welding process was carried out on a computer numerical control milling machine SOLARUCE TA–20A. Linear FSW welding was performed using a commercial tool from RSS SCHILLING with the symbol 10–K–4–Z–M–O, which is fabricated of hot work tool steel. Constant parameters of the technological process were applied. The welding process was executed for different values of the shoulder depth ZS.FindingsThis paper investigated the dependence between the thinning of the welded material and the depth value of the tool shoulder during the FSW process. The influence of the depth value of tool shoulder on joint strength in the static tensile/shear test was also performed. With the increase of the depth of the tool, the size of flash and structures of the face of the joint changes as well (its annular surface resulting from the tool’s work and the accompanying process of material flow on the run-off side). Such conditions in the process require a proper tool depression to reduce the occurrence of flash and minimize material thinning to achieve high joint strength and maintain the conditions for plasticizing the material.Practical implicationsBased on the experimental tests carried out, a number of guidelines for the correct conduct of the welding process can be outlined.Originality/valueTaking into account the various aspects of the process, the optimal range of the tool depth into the material is a value of approximately 0.06 mm. At this value, the face of the weld is not porous; the flash is easily removed; and the strength of the joint and the deformation of contact line are at an acceptable quality level.