Abstract
We reported the displacement (initial warpage) observed just after a molded part with ribs taken out from a mold affects the final warpage in injection molding and has close relationship with the accuracy of numerical analysis. In this paper the main influence of the rib geometry on the initial warpage was investigated using molding parts with different rib layout. As a result, it was confirmed that the stress which is asymmetrical in the wall direction is generated by inhomogeneous restriction from the ribs geometry of the mold cavity when a molten polymer solidifies in the mold, and this stress is the main cause of the initial warpage.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.