The influence of temperatures on the mechanical properties and fracture behavior of rocks under mixed mode I/II loading

Abstract

A comprehensive understanding of the fracture behavior of pre-heated rocks under to mixed mode I/II loading is crucial for deep underground engineering. The effect of high temperature on the fracture process zone (FPZ) and fracture toughness of rocks was experimentally investigated using semi-circular bend (SCB) samples. Surface displacement and associated strain field under loading were captured using digital image correlation. The results showed that the mechanical properties of SCB samples gradually decreased with increasing temperature. Rocks exposed at temperature exceeding 600 °C demonstrated a significant reduction in peak load, generalized stiffness, fracture toughness, and absorbed energy. Moreover, the load–displacement curves and macroscopic fracture characteristics of pre-heated SCB samples revealed a transition from brittleness to ductility with increasing temperature under mixed mode I/II loading. Both the length and width, as well as the crack tip opening displacement of the FPZ, increased with rising temperature. At lower temperatures (25 ∼ 400 °C), the ratio of FPZ length to width typically ranged between 2 and 3. While, at elevated temperature (600 ∼ 1000 °C), this ratio expanded to between 3 and 4. The initiation of thermally induced cracks in rocks will accelerate damage evolution under mixed mode I/II loading, as indicated by the development of the maximum principal strain with displacement. Scanning electron microscopy and polarization microscopy images of the microscopic fracture morphology in pre-heated rocks illustrated isolated and dispersed microcracks appeared at lower temperatures, whereas at elevated temperatures, intricate microcrack networks and broken grains were observed.