Abstract
During orbital forming, the material flow is realized both by radial and transversal motion. By orbital motion of the upper die and vertical motion of the bottom die, the material is transferred from area of active plastic deformation to area of passive plastic deformation. At the edge parts of semi-product arise, a compressive stress that leads to a deformation increase in the comparison with classical technology. The paper presents an analysis of the results that have been obtained by testing the method of orbital forming for low-carbon steel, as well as the guidelines for ensuring an optimum process mode for symmetrical elements.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.