The Influence of Surfactants on the Peel Strength of Water-based Pressure Sensitive Adhesives

Abstract

Listen

Translate article

In order to study the effect of surfactants on the adhesive properties, peel measurements were performed with two series of model polymers of ethylhexylmethacrylate (PEHMA), the first prepared by emulsion polymerization with four anionic surfactants, and the second by post-adding the same surfactants to a surfactant-free latex. Cohesive fracture is observed at low peel rates; the peel strength depends on the bulk mechanical properties and is independent of the emulsifier. A transition to another type of separation occurs at higher peel rates, which seems to be an interfacial failure by visual inspection. Surface analytical studies, however, give evidence that this “interfacial” failure is, in fact, a mixed failure, leaving traces of the polymer on the substrate surface. The peel rate at this transition as well as the peel strength at mixed fracture are influenced by the surfactants. Large differences were observed between the four surfactants as well as between both series of polymers, leading to the conclusion that the surfactants have a different mobility within the film. This is also reflected by a different aging behaviour of the films.