Abstract
A positive segregation is usually formed on the casting surfaces produced by high-pressure die casting (HPDC). In diecast Al-Si-Cu alloy components, this segregation shows a higher content of Si compared to the nominal composition of the alloy and it drastically affects the anodizing response of the casting surface. In the present work, HPDC components were produced by AlSi11Cu2(Fe) alloy, grit-blasted, and then anodized in a sulfuric acid electrolyte at the temperature of -4.5°C. Before the anodizing process, some regions of the casting were also milled, in order to completely remove the surface segregation. Microstructural investigations were carried out on grit-blasted and milled surfaces to characterize the initial substrates before anodizing, and to study their effect on the growth of the anodic layer. Scratch and wear tests were also performed to investigate the surface mechanical properties after anodizing. The results show that the surface segregation and the rough surface present on grit-blasted substrate leads to the formation of a thin and homogeneous anodic layer. On the contrary, a thicker and scalloped oxide film is formed on the milled surfaces. After anodizing, grit-blasted surfaces show lower wear and scratch resistance than milled substrates. The presence of surface segregation prevents the thickening of the anodic layer, negatively affecting the surface wear resistance due to the reduced oxide thickness.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
