The influence of rotator cuff tears on muscle and joint-contact loading after reverse total shoulder arthroplasty.

Abstract

Rotator cuff tears are known to affect clinical outcome of reverse total shoulder arthroplasty (RSA). This study aimed to use computational modelling to quantify the effect of rotator cuff tear severity on muscle and joint forces after RSA, as well as stresses at the glenosphere, base-plate, fixation screws, scapula, and humeral components. A multi-body musculoskeletal model of the glenohumeral joint was developed comprising the scapula, humerus and nine major upper limb muscles. Simulations of abduction and flexion after RSA were performed in the case of the intact rotator cuff and tears to (i) supraspinatus; (ii) supraspinatus and infraspinatus, and (iii) supraspinatus, infraspinatus and subscapularis. The intact and supraspinatus deficient rotator cuff resulted in the largest calculated muscle forces, glenohumeral joint contact forces and implant stresses. Peak glenohumeral joint forces during flexion were lower than those during abduction in all cases; however, substantially more posterior joint shear force was generated during flexion than abduction. A tear involving the supraspinatus and infraspinatus reduced glenohumeral joint forces by a factor of 8.7 during abduction (603.1 N) and 7.1 during flexion (520.7 N) compared to those in the supraspinatus deficient shoulder. RSA with an intact or supraspinatus deficient rotator cuff produces large glenohumeral joint forces that may increase base-plate failure risk, particularly during flexion when posterior shear forces are largest. Infraspinatus tears after RSA greatly reduce glenohumeral joint compression and may ultimately reduce joint stability. Future research ought to focus on experimental validation of subject-specific muscle recruitment strategies and joint loading after RSA. © 2018 Orthopaedic Research Society. Published by Wiley Periodicals, Inc. J Orthop Res.