The Influence of Residual Stresses Induced by Near-Net-Shape Blanking Processes on the Fatigue Behavior under Bending Loads

Abstract

Gears manufactured by blanking can be found in many different products like hammer drills or automobiles. Here, only the functional surface, the clean shear, can be used to transmit torque. Therefore, parts in serial production demand a high amount of clean shear, so the required torque can be transmitted with a minimal thickness and part weight. To achieve this, these parts are usually manufactured by fineblanking or related Near-Net-Shape Blanking processes (NNSBPs). Furthermore, the gears are subjected to cyclic loading which can, especially in the highly stressed tooth root, lead to tooth breakage. The effect of different process variants and process parameters on the residual stresses and the fatigue behavior under a pulsating bending load has not been investigated yet. Due to the potential of endurance improvement of blanked gears, this topic is addressed in this paper. To accomplish this, C-shaped profiles are manufactured by five different Near-Net-Shape blanking processes. The investigated processes are fineblanking, precision blanking with and without blank holder, and blanking with a small die clearance with and without a v-ring. The sheet metal material, S355MC (material number 1.0976) with a thickness of 6 mm, is first subjected to a stress relief heat treatment to minimize residual stresses induced by the specimen preparation and to ensure a defined initial residual stress state. After blanking, the residual stresses of the parts are measured. Finally, fatigue strength tests are carried out under a pulsating bending load on the C-shaped profiles with shear-cut edges. The results show that the residual stress state, as well as the part’s fatigue behavior are strongly influenced by the chosen blanking process.