Year-end Sale % OFF 
Abstract
Polyolefin plastomer films formulated with slip and antiblock were blown on a wide die gap with and without two DynamarTM polymer processing additives (PPAs). A wide die gap was used so that melt fracture-free film could be obtained with no PPA present for comparison purposes. The films were analyzed for the following properties: surface tension (on treated films), gloss, haze, clarity, transmittance, hot tack, heat seal, COF and block. In addition, the surface of films was examined using ESCA (Electron Spectroscopy for Chemical Analysis) and SSIMS (Static Secondary Ion Mass Spectrometry) to determine the surface chemical composition. PPAs when used at typical dose levels were shown to have essentially no effect on the surface and optical properties of plastomer films.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
