The Influence of Lubricant Upon EHD Film Behavior During Sudden Halting of Motion

Abstract

Although steady state elastohydrodynamic (EHD) lubrication is quite well understood both from the theoretical and from the experimental point of view, studies of transient effects in EHD are currently far less developed. This paper describes an experimental investigation into EHD film behavior during sudden halting of motion. A technique has been devised which enables both central lubricant film thickness and film thickness profiles to be measured every millisecond during halting of a ball on flat, sliding contact. This has enabled detailed information of influence of lubricant on film collapse during halting to be obtained. It is shown that film collapse occurs in two stages. The first is a very rapid reduction in film thickness with only very small changes in film geometry and thus pressure distribution. This is followed, as soon as entrainment ceases, by the formation of a lubricant entrapment, and subsequent slow leakage of fluid from the central film region. This paper focussed on the formation of this entrapment and the influence of the rheological properties of the lubricant, i.e. viscosity and pressure-viscosity coefficient, on its development and behavior. Presented at the 54th Annual Meeting Las Vegas, Nevada May 23–27, 1999