Abstract
Electrical Discharge Machining (EDM) is a non-contact machining process that becomes famous in machining of Polycrystalline Diamond (PCD). The material is typically used as the cutting tools for aerospace and automotive industries. However, low electrical conductivity and high melting temperature of PCD has caused slower EDM process. This investigation purposely designed to investigate the influence of different types of electrode which are Copper (ordinary electrode) and Copper-Nickel (newly proposed graphitization catalyst electrode) on EDM performance of MRR and Ra. Interestingly the newly proposed electrode gave positive impact to the investigated performance indication. Cu-Ni electrode recorded 35% better in MRR than the Cu electrode, though with higher short-circuiting rate. Cu-Ni also provided the lowest Ra value with 10% better than the best Ra produced by Cu electrode. This phenomenon occurred as due to the high interaction between the catalyst materials of nickel and diamond which supported by the qualification data provided in this investigation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
