Abstract
Joining of magnesium alloys was successfully performed by friction stir welding (FSW) technique. This study was aimed in characterizing the microstructure developed after the FSW and its influence on the mechanical properties. The developed microstructure was observed by using optical microscopy, from the cross-sectional side of welded sample. In this study, FSWed of two dissimilar magnesium (Mg) alloy sheets with low aluminum (AZ31) and high aluminum (AZ91) content were successfully conducted at varied welding speed of 60, 80 and 100 mm/min and tools rotational rate of 800, 1000 and 1200 rpm. The microstructure consists of fine and equiaxed recrystallized grain structure especially at the stir zones. The result of the tensile test indicated that the grain size variation of the joint showed an effect on the mechanical properties and fracture location of the joint. An increasing trend of hardness profile revealed more amount of dissolution of aluminum at the stir zone. From the result, FSW can be concluded as effective joining technique for dissimilar magnesium alloys and produced a defect free joint.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Automotive and Mechanical Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
